Line in middle of rubber from boab

i currently have a ninja boab but im getting tired of the line appearing in the middle of the rubber from where it rests against the plastic in the boab. anyone els have this issue and can recommend a solution or a better boab that wont do this? thanks

https://windowcleaner.com/shop/aztec-samurai-boab?pt=9G

Put a small piece of duct tape on the center plastic part where the rubber is resting, solves the problem.

2 Likes

from what i can gather ive read that these do that same thing?

I have the same problem. I always thought I was just getting bad rubbers but then realized the same thing you did. Still haven’t figured out a permanent solution yet.

Rubber U Channels | PAR Group Have a hunt for something like this on eBay… neoprene is best…softer.

2 Likes

Is there a modification available yet for the Samurai BOAB to address the nicking of squeegee rubber? Jared?