Hey guys it has been quite a while since I have posted on here but I really need some advice! I have gotten back on here and started reading some of the posts! This place is a great way to learn new things! Anyways. Over the past month I have had two jobs in which one area of the job has a section of windows that are very high and at a place where everyone looks. Both times I have cleaned these windows after finishing realized they look pretty rough when the sun comes shining through. While cleaning them I would have sworn they looked amazing, but looking form the inside out they don’t even come close to great. Anyone know why this is? I know there can be a lot of variables in this type of situation. Both these jobs happen to be CCU and the windows were quite dirty previously. It is also quite hard to clean a window like this when you are 30’ off the ground. I get dizzy jus thinking about it. Anyways, would appreciate your comments!
It could be between the panes.
on brand new windows?
Try a micro fiber towel with pure water
I don’t know, it sometimes takes longer… make sure your solution doesn’t dry, and your tekneex are on point.
Maybe it is just that because I am so high up I ma not as focused on getting everything off and its hard with different angles to scrub everything off.
could you explain more what you mean?
If you don’t have access to deionized water, buy a bottle of water, pour it on a micro fiber rag. Buff the Window with the wet rag and Buff it dry with a dry micro fiber rag
I know what you mean … are you laddering these .Try poling them on a cloudy day although 30 feet is up there. I have had to sometimes except poorly designed buildings ,windows etc and do the best I can …
Did you scrape them ?
Btw good to see you back. Jay.R. Better you than JKim Ha
I never had the opportunity to do drops at night I bet it is awesome
I try not to scrape…I am too afraid haha. Good to be back!
Looks like a lot of fun!!!
